In Half 4 of our Tekno RC ET48 2.0 construct sequence, we assemble the steering system, connect it to the entrance clip and add that to the chassis. We’ll even be putting in the rear clip to the chassis in addition to the middle bulkhead, heart diff and entrance/rear drive shafts.
Benefit from the video.
//TOOLS USED IN THIS VIDEO
MIP 1.5mm Hex Wrench: https://bit.ly/330HjTB
MIP 2.0mm Hex Wrench: https://bit.ly/2Gb8G5k
MIP 2.5mm Hex Wrench: https://bit.ly/3jsxR1M
MIP Instruments 3-Pack (1.5, 2.0, 2.5): https://bit.ly/3gQ7t06
ProTek Nut Driver Set (5.0, 5.5, 7.0, 8.0): https://bit.ly/35jDdrj
STRC Shock Pliers: https://bit.ly/2LynD41
ProTek Curved Scissors: https://bit.ly/2QIa9SD
Excel Needlenose Pliers: https://bit.ly/2Gk7soA
Excel Interest Knife: https://bit.ly/3s0q1kn
Hudy 17mm Wheel Nut Software: https://bit.ly/3sLCR7c
STRC Aluminum 4mm/5mm Turnbuckle Wrench: https://bit.ly/3tpiFYD
ProTek Calipers: https://bit.ly/3lHx5jd
ProTek Double-Sided Tape: https://bit.ly/2QHb3ix
ProTek Shock Stand: https://bit.ly/2Xysmpv
//RC GEAR WE USE
//CHECK OUT OUR MERCH
Discover: A few of our articles, movies and descriptions might comprise affiliate hyperlinks, which signifies that for those who click on on one of many product hyperlinks, we might obtain a small fee. This helps assist the web site and social media channels and permits us to proceed to supply content material. Thanks for the assist!
#teknorc #teknoet4820 #teknotakeover #competitionx #tonyphalen