From Locked Up RC:
Our 1.9″ 8 Gap Ring Inserts are a unbelievable manner so as to add a little bit of coloration and perhaps some {hardware} to your Locked Up RC wheel set.
Like our well-liked “Backlight Glow Rings”, these inserts are sandwiched between your current bead lock ring and wheel.
These Ring Inserts protrude from behind your ring to supply a numerous quantity of coloration relying on setup.
In addition they characteristic 8 holes which you can thread 1-64 screws into.
We like to put in the screws then reduce flush on the again with wire cutters.
Do NOT use a rotary software (Dremel) as the warmth from the reduce might injury the insert.
Locked Up RC 1.9″ Halo Ring Inserts
These inserts can be utilized with ANY of our 1.9″ bead lock rings.
They appear nice Agile, Demon & Sever rings.
In case you are including {hardware}, be sure there is no such thing as a battle together with your ring model.
EX: You would not put these behind a Tarantula, Galaxy or TR Ring and add {hardware}.
If you’ll add {hardware}, we advocate our Torx or Demon rings.
What’s included:
- 1x 1.9″ 8 Gap Copper Ring Insert
Specs:
- FDM printed with PLA
- Matte End
- ~ 41mm outer diameter
Printed components might require you to do some last deburring. Similar to plastic components from a components tree.
So, BEFORE set up, please examine the piece for any burrs that have to be eliminated.
To put in:
1. Take away your outer bead lock ring and lay your wheel face up.
2. Place the Insert Ring into the wheel in order that the facet with the “flange” is on the high.
3. Reattach the bead lock ring and tighten to softly push insert into place.
4. Confirm that the bead lock ring is flush in opposition to the wheel (examine from the perimeters).
(If the ring shouldn’t be sitting flush, examine for alignment and burrs.)
#2102-Copper – 1.9″ 8 Gap Copper – $3.00
#2102-Pineapple – 1.9″ 8 Gap Pineapple – $3.00
Visit LockedUpRC.com
See more posts about Locked Up RC
The put up Locked Up RC 1.9″ 8 Hole Ring Inserts appeared first on RC Car Action.